Skip to main content
Shape how your video sounds with Effects under Audio settings in the editor’s Audio panel. Pick a voice preset, or build your own chain of effects such as an equalizer, a compressor, reverb or echo. To change only part of a clip, select it on the timeline and click Effect.
Effects in Audio settings apply to every clip in your video, but not to background music.

Open the Effects section

  1. Open your video in the Tella editor.
  2. Click Audio in the left toolbar.
  3. Click Audio settings (the sliders icon) in the panel header.
  4. Find Effects, below Studio Voice.

Start from a preset

Click a preset to apply it. Each one shows a small picture of how it changes the sound:
  • Clear voice
  • Warm
  • Broadcast
  • Phone
  • Room
  • Hall
A preset replaces all the effects you’ve added. The preset stays highlighted until you change one of its effects.

Add an effect

Click Add next to Effects and choose an effect. Each one has a short hint in the menu: You can add up to 16 effects. They run in order from top to bottom, so an echo added after a reverb sounds different from one added before it.

Adjust an effect

Each effect appears as a card with a live graph of what it does. Click the card’s name to expand it and show its sliders.
  • Drag a slider to change a setting. You hear the change as you drag.
  • Double-click a slider to reset it to its default.
  • Use the switch on the left of the card to turn the effect off without removing it.

Equalizer bands

The Equalizer shows each band as a colored handle on its graph:
  1. Drag a handle to change that band’s frequency and gain.
  2. Double-click the graph, or click + in the band strip, to add a band. You can have up to 8.
  3. Select a band in the strip and pick its shape: Low shelf, Bell or High shelf.

Reorder, reset or remove effects

Click ⋯ on an effect’s card to:
  • Move up or Move down in the chain
  • Reset the effect to its default settings
  • Remove the effect
To remove every effect at once, click Clear next to Effects.
Echoes and reverb tails carry across cuts within a clip, so the sound doesn’t stop abruptly at each cut.

Add an effect to part of a clip

To put an effect on one stretch only, such as a phone voice for a quote or reverb on a single line:
  1. Open Audio in the left toolbar.
  2. Drag across the clips on the timeline to select the part you want to change.
  3. Click Effect in the toolbar above the timeline and pick a preset: Clear voice, Warm, Broadcast, Phone, Room or Hall.
You can also right-click a selection in any tool and choose Audio effect. While the range is selected, the top of the Audio panel shows a Selection chain where you can add, adjust or clear effects for that part only. The rest of the clip plays as it is. The effect shows as a card on the Audio row of the timeline, named after its preset or effect. With Audio open:
  • Click the card to edit its chain in the Audio effect panel.
  • Right-click the card to switch preset, choose Edit effects…, or choose Remove effect.
  • Drag either end of the card to change how much of the clip it covers.

Studio Voice

Remove background noise and give your voice a studio-quality finish.

Adjust audio levels

Balance your microphone and system audio.
Last modified on November 19, 2026